Arduino motor driver shield mounted on Arduino by 4 DC motors or 2 stepper motor (unipolar or bipolar) and at least 2 L293D motor driver ICs on a card that allows you to control 2 servo motors are there. There are a total of 4 H bridges in these integrations. It allows 0.6A current to flow through each bridge. (Instant 1,2A) The card is sent completely soldered. Since the number of motors that the Arduino Motor Shield can drive is large, the number of pins used is also large. 

The Shield uses all pins except 8 pins, including Pins 2, 13, A0-A5. Therefore, this motor together with the drive has an extra sensor, etc. if it is to be used, attention should be paid to the remaining pins.

• Independent control of 4 DC motors
• Independent control of 2 stepper motors
• There are connectors for 2 servo motors. In addition, the cable can be pulled from the pins to drive more servo motors. 
• There is a reset button and an external power input for the motor supply.
• It can provide continuous 0.6A and instantaneous 1.2A current from each channel. 
• There are empty analog input pins for sensor connections.
• Arduino Uno, Arduino Mega etc. it works compatible with controller cards with pin structure.
• Working Voltage: 5-12V
• Product Dimensions: 69x53x14.3mm
• Weight: 32g